Press and hold the LED button to bring the replica lightsaber out of sleep mode. You will hear a “Power On” voice and the LED button will turn on.
Press the button once to turn the LEDs in the blade on.
The following controls become active when the blade is on, you will know as the LED button will flash.
A quick press will initiate a single blaster deflect effect.
Press and hold the button until you see a Flash then release. This will initiate the drag effect, drag your saber tip along the tip to intimidate your duelling partner.
Press and hold the button until you see two flashes then release… This will initiate the colour cycle. When the colour your seeking reveals itself to you press the button again to end the colour cycle, selecting that colour.
Continue to hold the button after you see two flashes to turn off the blade LEDs.
While the blade is off, the following controls are activated based on the flash of the LED button light:
Press and hold the button until you see a flash, then release. This will change the volume, there are 3 volume settings on this replica lightsaber. Volume high, volume low and mute.
Press and hold the button until you see two flashes, then release. This will change the blade mode. There are several blade modes to choose from. Steady, pulse, rainbow blade, unstable blade, and fire blade. Play around with these blade modes to get the effect your after!
Press and hold the button until you have seen three flashes. This will change the blade mode. There are several blade modes, including some pre-on effects. Blade effects will affect pre-ons but will not have any effect on blaster blade or ghost blade modes. Only blade colour and font selection impact these modes.
Press and hold the button until you see four flashes, then release. This will change the sound font. The selection of fonts can be customised by the user.
Advanced Motion Controls
A direct and quick stab motion with the hilt will turn the blade on or off.
A quick twist while the hilt is pointed down will change the font to the next on the list.
A quick twist while the hilt is pointed up will play a music track, a quick twist again will stop the music.
Hold the button and impact the hilt or blade to activate lockup. Release the button to end lockup.
While holding the button a quick twist while the hilt is pointed down will change the selected blade colour. Release the button to select the current colour.
While holding the button, a quick twist while the hilt is pointed up will play a special effect.
Once purchased you will be sent full instructions on how to update the firmware. You can also convert soundfonts with the SD card, instructions on how to customise these fonts will be provided.
